10mm Aqua4 Grade 40 Calibrated Anchor Chain

Clearance 10mm DIN766 AQUA4 Grade 40 Calibrated Anchor Chain

Hot Dip Galvanised Anchor Chain

DIN766 = 10X28

Manufactured by Maggi Catena in Italy

Every link is proof load tested

Last Remaining Lengths available

£ 96.60 VAT incl.

£ 120.75


Calculate Delivery Cost

10mm DIN766 (10x28) AQUA4 Grade 40 Calibrated Anchor Chain:

10mm DIN766 Sample Certificate

There are two main calibrations for 10mm chain - DIN766 (10x28) and ISO (10x30)
It is very important to check the size and calibration of your gypsy/chain before you order
If you are unsure we can help you to decide - we will take all reasonable steps to ensure you get the correct chain

The simplest way to check that you are buying the correct calibration is to take a measurement from your existing chain, providing of course that it fits correctly.

We measure 10 links because, in practice, it is difficult to measure one link accurately enough.
The links should be laid out flat and pulled tight.
Measure from the outside edge to outside edge.
Compare your measurement with our stock:
Jimmy Green Stock: 10mm AQUA4 DIN766 = approximately 295mm; 10mm ISO = approximately 315mm
Calibrated Chain - General Information

N.B. The measurement for an old chain may be a little longer than new due to a degree of wear and elongation in use
10mm DIN766 and ISO Calibration pitch tolerance is Plus or Minus 0.6mm per link

10mm AQUA4 Grade 40 Anchor Chain is generally suitable for yachts up to approximately 16 metres, length overall
Factor in:
Displacement : Length ratio
Your cruising intentions
The anticipated anchorage conditions e.g. depth, seabed holding characteristics, the length of fetch and degree of exposure to prevailing winds
The length of chain that will be deployed and any extra scope provided by an anchor warp
The weight and design of anchor

Your anchor rode is only as strong as the weakest link so ensure that all your connectors and shackles are rated to the requisite break load

10mm AQUA4 Grade 40 Calibrated Anchor Chain is manufactured, hot dip galvanised and proof tested in house, at the Maggi Catena factory in Italy
Every link is tested to the proof load during production

10mm DIN766 Dimensions

Chain Size (D)Outside Width (B) Outside Length (L)Pitch (P)
10mm34mm 47mm28mm

10mm DIN766 Specification

Maximum Pin Dia.Proof LoadBreak Load  Weight per metre

Every link is tested to the proof load during the manufacturing process ensuring that each weld has been completed successfully

1Kn Force = 101.972Kg Break Load

62.8Kn = approximately 6400kg

Maximum Pin Diameter refers to the largest pin which will fit comfortably in the end link of 10mm chain whether it is DIN766 or ISO

Select the largest possible galvanised shackle (or anchor connector) by pin diameter to fit the chain

A copy of the Maggi Catena Test Certificate is available with your order on request

Quality Control and Accountability
Every length of chain is checked and labelled with the manufacturer, the date received and a corresponding batch number when it arrives.
The batch number is then recorded at the point of sale.
Every chain order is therefore traceable and accountable to the manufacturer Test Certificate

For comparison with 10mm ISO

10mm ISO Dimensions

Chain Size (D)Outside Width (B) Outside Length (L)Pitch (P)
10mm35mm 49mm30mm

10mm ISO Specification

Maximum Pin Dia.Proof LoadBreak Load  Weight per metre

You may also like