Barton High Load Eyes

High Load Eye with Dyneema Loop

	Part No.	External Ø mm	Internal Rope Ø mm	Bore Dia Ø mm	Length mm	SWL Kg	Weight g
High Load Eye with Dyneema Loop
High load eye with Dyneema loop - 12mm	60 460	-	-	12	100	750	11
High load eye with Dyneema loop - 22mm	60 461	-	-	22	230	2400	91
High load eye with Dyneema loop - 28mm	60 462	-	-	28	310	3600	152
High Load Eye
High load eye - 12mm	60 450	12	3	6	-	300	0.8
High load eye - 26mm	60 451	26	6	12	-	800	5.0
High load eye - 38mm	60 452	38	10	16	-	1800	24.0
High load eye - 52mm	60 453	52	12	22	-	3300	52.0
High load eye - 65mm	60 454	65	16	28	-	4500	104.0

Wear resistance

Independent laboratory tested Using Marlow D2 Dymeena 12 strand line.

After 450,000 cycles (50,000 metres of line), over 300 hours on an abrasion test machine - no visual signs of wear on the anodised coating could be found.

The Barton High load eye with loop is available in 3 sizes and can be used in various applications on board including barber hauler, preventers, mast base block tidies, emergency blocks, occasional blocks and toe rail blocks etc.

The High load eye combined with the Dyneema loop gives you a fast, efficient, simple and extremely strong solution to changing the direction of any line. The ‘Spectro’ anodised aluminium eye is designed to have very good wear resistant properties with low friction, this combined with the Dyneema loop gives you exceptional low weight to very high performance load ratio.

High Load Eyes

Available in 5 sizes. Manufactured in marine grade aluminium and finished in our unique hard ‘Spectro’ grey anodising. These lightweight high load eyes are suitable for a variety of uses on board, from lazy jacks, barber haulers, mast base tidies to stanchion lead eyes. The smallest size can be attached using a 3mm line with a bullseye diameter of 6mm. The largest size can be attached using a 16mm line with a bullseye diameter of 28mm.

Barton Low Friction Rings

High Load Eye with Dyneema Loop

Deck Hardware Support