Petersen Stainless Insulators - Compression and Toggle Fork

Swageless compression fitting for wire termination and toggle fork for fitting to backstay eye.

2 insulators are required to create an insulated backstay.

£ 211.30 inc VAT

Calculate Delivery Cost

The only fail safe rigging insulator for wire available on the market today, the Hi-MOD backstay insulator has an internal ball-socket in the main body.

The nut is insulated from the stainless steel body by a Tufnol™ spacer, preventing electrical transference to the insulator body or opposite terminal.

Should, for any reason, the Tufnol™ be compromised, the nut will bottom out against the stainless housing.

While the backstay will loosen, the insulating studs will remain attached to the insulator body, allowing the rig to be re-tensioned until a repair can be made.

Wire Diameter (mm)Pin Size (mm)Hole Size (mm)C-L (mm)T-L (mm)
61111.1110147
712.712.7131169
81414.28153212
101616.2159212
121919.05192258
142222.2222297
162525.4258337

You may also like