10mm Titan Grade 43 Calibrated Anchor Chain

Downloads include Titan Sample Test Certificates and Grade 43 Specification for DIN766 and ISO

10mm Titan Grade 43 Calibrated Anchor Chain is manufactured, hot dip galvanised, proof-tested and engineered by CMP to specifications exceeding DIN766

 Titan Marine Products are a brand of Canada Metal (Pacific) the manufacturers of the world renowned Rocna anchor.

Titan G43 Chain specification and the resulting higher than comparable Grade 40 break loads are testimony to the quality of the steel and the manufacturing process.

All Titan Marine Chains are manufactured and proof tested in a ISO-9001 environment to ensure their lasting quality and strength for yacht anchoring and mooring.

All Titan Grade 40 Chain is clearly embossed at regular intervals with G43, CMP and DIN766 or ISO as appropriate. This is a clear testament to their confidence in the chain and galvanising quality

All Titan Grade 43 Chain is hot dip galvanised to a minimum 100 Microns

10mm Titan Grade 43 Calibrated Anchor Chain is available in two different calibrations - ISO4565 (10 X 30) AND DIN766 (10 X 28)

It is very important to check the size and calibration of your gypsy/chain before you order

If you are unsure we can help you to decide - we will take all reasonable steps to ensure you get the correct chain

The simplest way to check that you are buying the correct calibration is to take a measurement from your existing chain, providing of course that it fits correctly.

We measure 10 links because, in practice, it is difficult to measure one link accurately enough.
The links should be laid out flat and pulled tight.
Measure from the outside edge to outside edge.
Compare your measurement with our stock:
Jimmy Green Stock: 10mm Titan DIN766 = approximately 297mm; 10mm ISO = approximately 316mm

DETERMINING THE CORRECT CALIBRATION

N.B. The measurement for an old chain may be a little longer than new due to a degree of wear and elongation in use

10mm Titan Grade 43 Anchor Chain is generally suitable for yachts up to approximately 16 metres, length overall
Factor in:
Displacement : Length ratio
Your cruising intentions
The anticipated anchorage conditions e.g. depth, seabed holding characteristics, the length of fetch and degree of exposure to prevailing winds
The length of chain that will be deployed and any extra scope provided by an anchor warp
The weight and design of anchor

Your anchor rode is only as strong as the weakest link so ensure that all your connectors and shackles are rated to the requisite break load

Titan Anchor Chain exceeds DIN766 specifications

MBL = Manufacture Minimum Break load

Chain size is the diameter shown in red on the diagram

Maximum Pin Ø (Diameter) refers to the largest pin which will fit comfortably in the end link of 10mm chain whether it is DIN766 or ISO

Select the largest possible galvanised shackle or anchor connector by pin diameter to fit the chain

Quality Control and Accountability
Every length of chain is checked and labelled with the manufacturer, the date received and a corresponding batch number when it arrives.
The batch number is then recorded at the point of sale.
Every chain order is therefore traceable and accountable to the manufacturer Test Certificate

A copy of the corresponding Titan Test Certificate is available with your order on request