Bonomi Joy Self Tailing Cleat - 12v 110kg
TMS-B3A121H
Moor to the pontoon with ease
Produced from AISI 316L stainless steel
Self tailing cleats safely reduce mooring line loads
For boats approximately 35 to 50 feet in length
Compatible with 3-strand, 8-plait and braided mooring lines between 20mm and 28mm
More Information
Downloads
The Bonomi self tailing cleat is equally effective at the stern or at the bow. It can be installed centrally at the bow or stern or as a pair alongside your existing side-deck cleats.
Warps must still be handled during operation of the self tailing cleat. However, handling loads and stress for the operative will be significantly reduced.
Safe operational tension load up to 110kg (1100N). The tailing speed of the winch is fast enough to facilitate the quick retrieval of slack line. The cleat motor is strong enough to load sufficient tension into a line to move a boat. Load the line using the cleat then allow the natural elasticity in the line to do the work. Repeat this cycle as often as required.
Manufactured in AISI 316L stainless steel
Motor voltage 12V
Pack includes:
- Single direction control box
- Single stainless steel foot switch
- 3m of cable
NB Mooring line recommendation above is incorrect. The correct diameters are 20-28mm.