Petersen Hi-Mod Swageless Compression Terminal - Toggle End

Petersen Hi-Mod Swageless Compression Terminal - Toggle End

Petersen Hi-Mod terminals are designed for easy assembly by using an exclusive ‘twist-click’ system.

This method is extremely beneficial on large diameter or Compact Strand wire where the strands are stiff and difficult to bend.

Hi-Mod twist and click assembly:

• Hold the end fitting against the crown ring
• Twist the body in the same direction as the lay of the wire while applying upward pressure.
• The outer wire strands will click into position on the crown
• If necessary, use a small screwdriver to reposition any strands that have inadvertently crossed

Petersen have producd a very informative video illustrating the twist and click method and how to fit their Hi-Mod terminals to wire successfully:

HI MOD INSTRUCTIONAL VIDEO

DS = Down size
US = Up size

NOTE:
Petersen Stainless use the following convention throughout their range – the pin size is the smallest diameter hole that our pin will fit into, the hole size is the largest diameter pin that will fit in the hole. For example, if we list a pin as being 12mm then the pin will fit into a 12mm diameter hole and conversely if we list a hole as being 16mm then a 16mm diameter pin will fit in the hole. If in doubt please ask.