Spinlock T-Series Deck Organiser

T-Series Organisers are used to guide multiple lines back from the mast along the deck to a group of powerclutches.

T25

• Small boat organiser - 25mm composite sheaves
• Maximum Line diameter = 10mm
• Symmetric 2 to 6 sheaves
• Asymmetric configurations available by request
• Fibre-reinforced construction
• Stainless steel ‘wear’ strip prevents local rope damage
• Curves to follow the shape of the deck
• Double stack with BE10/2 or /3 for lowest cost stacked line solution

T38 and T50

• Standard Boat Organiser - T38 = 38mm composite sheaves, T50 = 50mm composite sheaves
• Maximum Line diameter: T 38= 12mm, T50 = 14mm
• Efficient bearing surface reduces winch effort and increases halyard life
• Integral end fairings for safe side loading
• Asymmetric version reduces deck footprint and saves weight
• Can be stacked for limited deck area or adding extra capacity
• Vari-camber feature available by special request: designed to follow the curve of the deck when fitted

Installation

• Plan the layout of the deck before marking out holes
• The vertical rope-entry angle should be less than 10°
• Install the organiser on an imaginary line bisecting the angle of the rope lead
• Ensure the deck has the required strength
• Drill hole diameters:  T38 = ø6.5mm, T50 = ø8.5mm
• Refrain from bending the organiser to fit the deck curve - use a shaped hardwood pad.
• Seal the deck joint using a silicone rubber sealant.
• Insert flush-fitting countersunk fasteners before fixing to the deck.
• Use A4/70 A4/80 high tensile fasteners for maximum safety
• Sheave Diameters: T38=38mm, T50 = 50mm
• Fasten at both ends and through each sheave

User Instructions

• The sheaves are specially moulded in composite material to provide low friction even at high loads
• The durable stainless steel axle and countersunk fasteners provide a high strength/low weight construction
• The tensioned line must bear only on a sheave
• Do not allow contact between a loaded line and the organiser strap (body)
• In a double-stacked application, always use the lower row of sheaves for the highest loads

Maintenance

• Flush regularly with fresh water and apply a silicone spray or Spinlock grease when dry
• Do not use mineral oil or solvent-based based lubricants like “WD40”
• The wrong lubricants will degrade the bearing properties
• For foam sandwich deck installations, please consult Spinlock
• Never use cleaning or lubricating solvents because they will cause damage