Majoni Fender Valve Extractor Bolt
HT-M3x16mm-Single
M3 thread x length 16mm
Pozi Pan Head
A316 marine-grade stainless steel
For extracting and inserting Majoni fender valves
Fits all Majoni fenders and buoys
More Information
Accessories
Majoni uses the same unique design brass valve for all their fenders.
Majoni Valve Plus Factors:
- M3 thread
- Durable brass manufacture
- Non-return design function
- Easy to replace
- Fits all Majoni fenders
N.B. Do not open the non-return mechanism (flap) by pushing it too far with a metal pin or nail, because this may damage the valve.
Majoni warns that using a needle-type adaptor, particularly for inflation, will damage the valve.
Try to avoid deflating any of your Majoni fenders, but if necessary, probe into the valve with a biro pen, pushing only the minimum distance possible to gently open the non-return mechanism and listen for the air escaping.
Majoni recommend an optimum inflation pressure = 0.2 bar - at this pressure, it should be possible to visibly press in the fender wall with the flat of your hand
The pressure inside your fenders will change with the ambient temperature, so it is important to keep a check on the inflation
Majoni Valve Replacement Instructions:
To replace a damaged Majoni valve:
- Screw an M3 threaded bolt or machine screw into the valve,
- Grip the bolt head firmly with a pair of pliers and pull the valve out of the fender wall
- Push the new valve into the hole in the fender wall by the same method i.e. using a bolt, pliers and hand pressure.
