Mantus Galvanised Anchor

Mantus Marine USA Design 

Hot dip galvanised

from 8lb (3.6kg) to 175lb (78kg)

Dismantles for convenient stowage

Deep penetrating flukes

Quick setting design

45lb anchor not available until mid November

£ 160.80 inc VAT

Calculate Delivery Cost

Mantus Marine USA anchors are world renowned for their outstanding setting and holding properties

Digs like no other anchor

Mantus Anchors are designed to penetrate dense grassy bottoms and set with unparalleled holding power.
When tested, Mantus Anchors set faster and deeper than any other tested anchor, including Rocna, Manson Supreme, Bulwagga, Fortress, Bruce, CQR and Danforth anchors.

Easy to stow
Mantus Anchors break down for tidy storage, so you can stow one or two as spares without taking up much needed locker space.

Strong Design and Manufacture

Mantus Anchor Features:

  • Formed from high quality steel plate
  • No cast parts
  • Shank and shank boot are welded from both the top and the bottom
  • Shank and roll bar are bolted to the fluke
  • ASTM certified steel bolts are oversized with a large safety margin
  • Although the shank is attached to the fluke with 4 bolts, a single bolt would have sufficient strength to handle the maximum expected load on the anchor
  • Every part of the anchor is hot-dipped galvanised for corrosion protection
  • The shank is produced from HT/ASTM 514 high quality steel and the flukes are from the mild steel A36 equivalent
  • Sharp-headed precision machined nose - formed into the perfect chisel shape to achieve maximum penetrating power
  • Small holes (flush with the roll bar) are to vent air in the galvanisation process to promote even coverage 

Mantus Marine offer a Lifetime Warranty on all anchor parts and a 3 year warranty on the galvanising.

Mantus Marine Anchor Size Guide
Mantus publish a comprehensive Anchor Sizing Guide based on extensive testing and feedback, see below.
The size chart is based on sustained high winds and poor holding conditions (low viscosity sea bed) for a cruising yacht spending most of her time at anchor
N.B. Comparing surface area can be a good judge for potential holding capability.

Mantus anchor sizing recommendations are presented in the table, divided into three categories:

  • Lunch Anchor - recommended for lighter use with expected winds under 30 knots
  • Working Anchor - recommended for winds up to 50 knots
  • Storm Anchor - recommended for winds above 50 knots

Mantus believe in making their recommendations assuming the worst case scenario.
The result may seem conservative compared with other manufacturers but they believe it is more realistic.

Mantus Anchor Assembly Instructions

Mantus Anchor Dimenions
Mantus Anchor Dimensions in mm:

SizeABCDEF
8lb / 3.6kg305386331472166196
13lb / 5.9kg 371470403576203239
17lb / 7.7kg410519445636224264
25lb / 11.4kg443562482687242285
35lb / 15.9kg493625536765269318
45lb / 20.5kg554702602859303357
55lb / 25kg592751644919324382
65lb / 29.5kg631800686979345407
85lb / 38.6kg6708507291039366432
105lb / 47.7kg7259207891125396467
125lb / 56.8kg7819908491211427503
155lb / 70.5kg88611239631374484571
175lb / 79.5kg947120110301469517610

Mantus Anchor Size Guide

Mantus Introduction on video

Anchor Test Videos

You might also consider

You may also like